brownie25 Posted February 22, 2011 Share Posted February 22, 2011 I am looking to build a guinea pig run out of angle iron and galvanised steel mesh but need to put a curve in to it so im looking for someone who can put a curve in angle iron Link to comment Share on other sites More sharing options...
smithy266 Posted February 22, 2011 Share Posted February 22, 2011 you will find it hard.... very hard... to bend angle iron without cutting it. Try asking somewhere like Ridgeway Forge, who can heat it then bend it. Link to comment Share on other sites More sharing options...
Michael_W Posted February 22, 2011 Share Posted February 22, 2011 You should notch one side of the angle iron so you can bend it, you should mark where you want to bend it and cut out a vee on one side of the angle iron ! Link to comment Share on other sites More sharing options...
GRA56 Posted February 22, 2011 Share Posted February 22, 2011 THE section benders at Dinnington will roll it for you. Turn left at Todwick cross roads ie. Red Lion crossroads ( A57 leaving Sheffield towards Worksop ) . Turn right onto industrial estate ( before new railway bridge ) THE is on right hand side ( about 250 yards down ) Link to comment Share on other sites More sharing options...
brownie25 Posted February 22, 2011 Author Share Posted February 22, 2011 thanks everyone Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.